Forumsee logo
Forumsee » Consumer Electronics » TVs » Read message
RSS: Subscribe to RSS

Insignia ns-32lcd 32" TV

Troubleshooting TVs and Video Sources - Badcaps Forums - www.badcaps.net
I have an insignia ns-32lcd the TV's standby red light flashes continuously once plugged in but no response from on button or remote. The power supply output of 5v is constant and the logic board is sending the on signal successfully. However, both 24v outputs of the power supply start at 24v regardless of the power button being pressed and fluctuate from 24v down to 9v and back up to 24v every few seconds. I've replaced all of the capacitors on the power supply board except for the large filter cap which reads about 295v when the TV is plugged in and is rated for 450v 150uf. Could this be the problem? Or would it be a problem with voltage regulation? Pictures of boards listed below.
Date: Dec 15, 2013   



Last videos:

Crack & pop on Yamaha receiver over S/PDIF when resuming playback
Crack & pop on Yamaha receiver over S/PDIF when resuming playback
Sharp LC-30HV4U - Red 3 Pattern Blinking LED Part 2
Sharp LC-30HV4U - Red 3 Pattern Blinking LED Part 2
Kdl-32bx300
Kdl-32bx300
48-50" LED TV < 50K - DLED or Edge LED ? Please advice.
48-50" LED TV < 50K - DLED or Edge LED ? Please advice.
48-50" LED TV < 50K - DLED or Edge LED ? Please advice.
48-50" LED TV < 50K - DLED or Edge LED ? Please advice.
Stranger Things on Netflix
Stranger Things on Netflix
Panasonic P42UT30 with 14 blinks.
Panasonic P42UT30 with 14 blinks.
Panasonic P42UT30 with 14 blinks.
Panasonic P42UT30 with 14 blinks.

Cars ·
Travel ·
Pets ·
production-frontend